CPPM orange ???
2 participants
Page 1 sur 1
CPPM orange ???
hello,
est ce que quelqu'un sait si le CPPM de chez orange ( compatible spektrum ) est compatible S-BUS ( comme futaba ) ?
on peut toujours rêver !?
si tel est le cas , je peux réduire considérablement le nombre de câbles sur les multirotors
merci d'avance pour vos nombreuse réponses
est ce que quelqu'un sait si le CPPM de chez orange ( compatible spektrum ) est compatible S-BUS ( comme futaba ) ?
on peut toujours rêver !?
si tel est le cas , je peux réduire considérablement le nombre de câbles sur les multirotors
merci d'avance pour vos nombreuse réponses
Re: CPPM orange ???
non, pas sur ce coup là...
Thierry le nabakou- il est des noootre !
- Messages : 1610
Date d'inscription : 21/03/2012
Age : 59
Localisation : Belgique
Re: CPPM orange ???
sur ce récepteur
https://www.hobbyking.com/hobbyking/store/__61211__OrangeRx_R410X_Spektrum_JR_DSMX_Compatible_4Ch_6CH_PWM_CPPM_2_4Ghz_Receiver_.html
ils disent , dans les discussions en bas que c'est "très similaire" au S.BUS de futaba .... ( mais similaire veut il dire compatible ? )
JeffBr 318 points - 10/14/2014
Ok, so how does this CPPM work and to which channel do you connect it.? Is it something like Futaba's S-Bus, where you loop all servos on one channel from the Rx and the servo adressing is done software wise... TIA and cheers, JeffBr.
Olof 94 points
It's very similar to S.BUS, in the sence that one cable takes care of all channels in serial mode. There are ways to connect servos to the same main signal cable like S.BUS. But the main purpose of CPPM it to connect to flight controllers (KK-controll board for multirotor, or FBL units for single rotor helis or even fixed wing flightcontrollers and autopilotes).
Peter 30 points
If it's like the R615X, the CPPM output is on the bind plug position. Allows for CPPM or standard output without any switches / jumpers.
https://www.hobbyking.com/hobbyking/store/__61211__OrangeRx_R410X_Spektrum_JR_DSMX_Compatible_4Ch_6CH_PWM_CPPM_2_4Ghz_Receiver_.html
ils disent , dans les discussions en bas que c'est "très similaire" au S.BUS de futaba .... ( mais similaire veut il dire compatible ? )
JeffBr 318 points - 10/14/2014
Ok, so how does this CPPM work and to which channel do you connect it.? Is it something like Futaba's S-Bus, where you loop all servos on one channel from the Rx and the servo adressing is done software wise... TIA and cheers, JeffBr.
Olof 94 points
It's very similar to S.BUS, in the sence that one cable takes care of all channels in serial mode. There are ways to connect servos to the same main signal cable like S.BUS. But the main purpose of CPPM it to connect to flight controllers (KK-controll board for multirotor, or FBL units for single rotor helis or even fixed wing flightcontrollers and autopilotes).
Peter 30 points
If it's like the R615X, the CPPM output is on the bind plug position. Allows for CPPM or standard output without any switches / jumpers.
Page 1 sur 1
Permission de ce forum:
Vous ne pouvez pas répondre aux sujets dans ce forum
|
|